Pi
2016.12.10 18:09

ATTINY85 PIN정보, Data sheet

조회 수 8976 댓글 2
?

단축키

Prev이전 문서

Next다음 문서

+ - Up Down Comment Print Files
?

단축키

Prev이전 문서

Next다음 문서

+ - Up Down Comment Print Files


PIN 설정

52713d5b757b7fc0658b4567.png




데이터 시트 요약

ATTINY25,45,85(V) Summary.pdf



데이터 시트(Full) : http://www.atmel.com/Images/Atmel-2586-AVR-8-bit-Microcontroller-ATtiny25-ATtiny45-ATtiny85_Datasheet.pdf



---------------


** Features(25/45/85) **


o High Performance, Low Power AVR® 8-Bit Microcontroller


o Advanced RISC Architecture

  - 120 Powerful Instructions   - Most Single Clock Cycle Execution

  - 32 x 8 General Purpose Working Registers

  - Fully Static Operation


o Non-volatile Program and Data Memories

  - 2/4/8K Bytes of In-System Programmable Program Memory Flash


o Endurance: 10,000 Write/Erase Cycles

  - 128/256/512 Bytes In-System Programmable EEPROM


o Endurance: 100,000 Write/Erase Cycles

  - 128/256/512 Bytes Internal SRAM

  - Programming Lock for Self-Programming Flash Program and EEPROM Data Security


o Peripheral Features

  - 8-bit Timer/Counter with Prescaler and Two PWM Channels

  - 8-bit High Speed Timer/Counter with Separate Prescaler


o 2 High Frequency PWM Outputs with Separate Output Compare Registers


o Programmable Dead Time Generator

  - USI   - Universal Serial Interface with Start Condition Detector

  - 10-bit ADC


o 4 Single Ended Channels


o 2 Differential ADC Channel Pairs with Programmable Gain (1x, 20x)


o Temperature Measurement

  - Programmable Watchdog Timer with Separate On-chip Oscillator

  - On-chip Analog Comparator


o Special Microcontroller Features

  - debugWIRE On-chip Debug System

  - In-System Programmable via SPI Port

  - External and Internal Interrupt Sources

  - Low Power Idle, ADC Noise Reduction, and Power-down Modes

  - Enhanced Power-on Reset Circuit

  - Programmable Brown-out Detection Circuit

  - Internal Calibrated Oscillator


o I/O and Packages

  - Six Programmable I/O Lines

  - 8-pin PDIP, 8-pin SOIC, 20-pad QFN/MLF, and 8-pin TSSOP (only ATtiny45/V)


o Operating Voltage

  - 1.8-5.5V for ATtiny25V/45V/85V

  - 2.7-5.5V for ATtiny25/45/85


o Speed Grade

  - ATtiny25V/45V/85V: 0-4 MHz @ 1.8-5.5V, 0-10 MHz @ 2.7-5.5V

  - ATtiny25/45/85: 0-10 MHz @ 2.7-5.5V, 0-20 MHz @ 4.5-5.5V


o Industrial Temperature Range


o Low Power Consumption

  - Active Mode:


o 1 MHz, 1.8V: 300 ?A

  - Power-down Mode:


o 0.1 uA at 1.8V



------------------


https://www.aliexpress.com/item/Digispark-kickstarter-Micro-development-board-ATTINY85-module-for-Arduino-usb/32584975067.html?spm=2114.13010608.0.0.UPTUQz


The Specs:

1. Support for the Arduino IDE 1.0 + (OSX/Windows/Linux).

2. Power via USB or External Source or 7-16 v to 5 v (automatic selection).

3. The On - board, 150 ma 5 v Regulator.

4. Built - in USB and serial was debugging).

5. 6 I/O Pins (2 are informs the for USB only if your program actively communicates over USB, otherwise you can use all 6 even if you are programming via USB).

6. 8 k Flash Memory (about 6 k after bootloader).

7. The I2C and SPI (vis USI).

8. PWM on 3 pins (more possible with Software PWM).

9. The ADC on 4 pins.

10. The Power LED and the Test/Status leds.


------------------------


Installing Digispark USB driver


Digispark use USB to communicate with computer, so your computer must install Digispark USB driver

1. Download Arduino for Digispark which come with USB driver

2. Extract the file (DigisparkArduino-Win32-1.0.4-March29.zip)  to any folder

3. Execute DigisparkArduino-Win32\DigisparkWindowsDriver\InstallDriver.exe to start installing the USB driver


아래 페이지를 보고 설정 및 설치할 것

http://www.instructables.com/id/Digispark-DIY-The-smallest-USB-Arduino/?ALLSTEPS



빌드 이미지 업로드시, 

보드를 뺀 상태에서 Uplaod > "Plug in device now" 메시지 보이면 연결 > 업로드 완료

해야 함


----------------------------------------------------------

[아두이노] 미니 개발보드 ATTiny85 보드(Digispark)의 설치 및 사용


http://deneb21.tistory.com/394


■ ATTiny85 Module (Digispark) Spec.

1. Support for the Arduino IDE 1.0 + (OSX/Windows/Linux).

2. Power via USB or External Source or 7-16 v to 5 v (automatic selection).

3. The On - board, 150 ma 5 v Regulator.

4. Built - in USB and serial was debugging).

5. 6 I/O Pins (2 are informs the for USB only if your program actively communicates over USB, otherwise you can use all 6 even if you are programming via USB).

6. 8 k Flash Memory (about 6 k after bootloader).

7. The I2C and SPI (vis USI).

8. PWM on 3 pins (more possible with Software PWM).

9. The ADC on 4 pins.

10. The Power LED and the Test/Status leds.


■ ATTiny85 Module Pin 정의

All pins can be used as Digital I/O (모든 핀들은 디지털 I/O 핀으로 사용 가능함)

Pin 0 → I2C SDA, PWM (LED on Model B)

Pin 1 → PWM (LED on Model A)

Pin 2 → I2C SCK, Analog In

Pin 3 → Analog In (also used for USB+ when USB is in use)

Pin 4 → PWM, Analog (also used for USB- when USB is in use)

Pin 5 → Analog In



■ ATTiny Chip Spec.


Features

 - High Performance, Low Power AVR® 8-Bit Microcontroller

 - Advanced RISC Architecture

 - 120 Powerful Instructions  - Most Single Clock Cycle Execution

 - 32 x 8 General Purpose Working Registers

 - Fully Static Operation

 - Non-volatile Program and Data Memories

 - 2/4/8K Bytes of In-System Programmable Program Memory Flash

 - Endurance: 10,000 Write/Erase Cycles

 - 128/256/512 Bytes In-System Programmable EEPROM

 - Endurance: 100,000 Write/Erase Cycles

 - 128/256/512 Bytes Internal SRAM

 - Programming Lock for Self-Programming Flash Program and EEPROM Data Security

 - Peripheral Features

 - 8-bit Timer/Counter with Prescaler and Two PWM Channels

 - 8-bit High Speed Timer/Counter with Separate Prescaler

 - 2 High Frequency PWM Outputs with Separate Output Compare Registers

 - Programmable Dead Time Generator

 - USI  - Universal Serial Interface with Start Condition Detector

 - 10-bit ADC

 - 4 Single Ended Channels

 - 2 Differential ADC Channel Pairs with Programmable Gain (1x, 20x)

 - Temperature Measurement

 - Programmable Watchdog Timer with Separate On-chip Oscillator

 - On-chip Analog Comparator

 - Special Microcontroller Features

 - debugWIRE On-chip Debug System

 - In-System Programmable via SPI Port

 - External and Internal Interrupt Sources

 - Low Power Idle, ADC Noise Reduction, and Power-down Modes

 - Enhanced Power-on Reset Circuit

 - Programmable Brown-out Detection Circuit

 - Internal Calibrated Oscillator

 - I/O and Packages

 - Six Programmable I/O Lines

 - 8-pin PDIP, 8-pin SOIC, 20-pad QFN/MLF, and 8-pin TSSOP (only ATtiny45/V)

 - Operating Voltage

 - 1.8 - 5.5V for ATtiny25V/45V/85V

 - 2.7 - 5.5V for ATtiny25/45/85

 - Speed Grade

 - ATtiny25V/45V/85V: 0  - 4 MHz @ 1.8 - 5.5V, 0 - 10 MHz @ 2.7 - 5.5V

 - ATtiny25/45/85: 0  - 10 MHz @ 2.7 - 5.5V, 0 - 20 MHz @ 4.5 - 5.5V

 - Industrial Temperature Range

 - Low Power Consumption

 - Active Mode:

 - 1 MHz, 1.8V: 300 μA

 - Power-down Mode:

 - 0.1 μA at 1.8V



  • Dreamy 2017.05.22 14:49
    https://learn.sparkfun.com/tutorials/tiny-avr-programmer-hookup-guide/attiny85-use-hints
  • Dreamy 2018.07.18 09:21

    Digispark ATTINY85 vin : 6.7~7V

    (78L05 레귤레이터 사용함)


Dreamy의 코드 스크랩

내가 모으고 내가 보는

List of Articles
번호 분류 제목 날짜 조회 수 추천 수
416 일반 마크다운 markdown (.md) 파일이란 2017.07.12 12225 0
415 Pi 아두이노 (Arduino)로 서보모터 (SG90) 제어 2017.07.11 10847 0
414 일반 배치파일(bat)에서 명령 실행결과를 변수에 저장하는 방법 2017.07.05 18841 0
413 LINUX 프로세스를 이름으로 단번에 종료하기 2017.06.07 8576 0
412 C++ istringstream 을 이용한 string type 변환 & 토크나이징 2017.06.07 8618 0
411 LINUX bluetooth on Ubuntu 2017.05.25 13459 0
410 Pi Raspberry pi 에 Bluetooth사용을 위한 bluez설치 및 실행 2017.05.24 9703 0
409 LINUX 블루투스 사용하기 hci tool 2017.05.24 11844 0
408 일반 BT와 BLE 2017.05.16 6528 0
407 LINUX [Shell Script] Bash 파일 유무 체크하는 방법과 파일 존재 검사 옵션 2017.05.16 21241 0
406 LINUX [Shell Script] Bash 실행결과를 변수에 담기 2017.05.16 13404 0
405 Pi SSD1306 OLED Displays with Raspberry Pi 2017.05.10 6636 0
404 Pi SPI란? (Serial Peripheral Interface) 2017.04.20 15472 0
403 Pi LCD interface 종류 및 Driver IC 2017.04.17 6212 0
402 Pi 아두이노의 인터럽트 (interrupt) 사용 2017.04.13 14341 0
목록
Board Pagination ‹ Prev 1 2 3 4 5 6 7 8 9 10 11 ... 34 Next ›
/ 34

나눔글꼴 설치 안내


이 PC에는 나눔글꼴이 설치되어 있지 않습니다.

이 사이트를 나눔글꼴로 보기 위해서는
나눔글꼴을 설치해야 합니다.

설치 취소

Designed by sketchbooks.co.kr / sketchbook5 board skin

Sketchbook5, 스케치북5

Sketchbook5, 스케치북5

Sketchbook5, 스케치북5

Sketchbook5, 스케치북5